You are here: Maintenance > Operator Routine Maintenance > Monthly > Inspect the Feeder Nylon Rollers

Inspect the feeder nylon rollers

WHAT YOU NEED 

Tools:Security Torx Key Set

Safety Equipment:Standard Personal Protective Equipment

Note: there are four side fence rollers, two side clamp rollers and two top clamp rollers in each feeder, which makes a total of 16 nylon rollers.

ClosedInspection
  1. Using the Manual Mode window, move the saw blade to the back of the saw chamber.
  2. Isolate the saw electrically.
  3. Remove both feeder transparent covers.
  4. Inspect the nylon rollers for any signs of damage, wear or flat spots.
  5. Gently move the 12 side rollers up and down, and the four top rollers sideways to make sure they have a small amount of play.

  6. Make sure they run freely and there is no sign of sticking.

    Note: If any roller or roller bearing needs to be replaced, contact Vekta Automation.

  7. Refit both feeder transparent covers.

ClosedTesting

CAUTIONWhen using the manual mode, make sure that everything and everyone is clear of moving parts to prevent damage or injuries.

  1. Turn on the electrical isolation switch on the front of the saw.
  2. Release the E‑stop button on the operator console.
  3. Rehome the saw.
  4. Open Simple.
  5. Using the Manual Mode window, feed in a stick of timber and make sure it feeds correctly.